NAJDENI IZDELKI

Hiter pogled

Podrobnosti ...

Cevi hlajenja motorja in prirobnice

ESEN SKV Gibka cev hladilnika

Blagovna znamka:ESEN SKV
Strana ugradnje:gore
Materijal:EPDM (etilen-propilen-dien kaučuk)
Unutarnji promjer 1 [mm]:38 mm
Unutarnji promjer 2 [mm]:38 mm

Podrobnosti ...

-33%

Trenutna akcija traje do: 21.05.2024 00:00.

Cijena:

50,40 €

Sniženo:

33,77 €

Šifra: ESE-24SKV274

Najniža cijena u zadnjih 30 dana: 33,77 €

Blagovna znamka:ESEN SKV
Strana ugradnje:gore
Materijal:EPDM (etilen-propilen-dien kaučuk)
Unutarnji promjer 1 [mm]:38 mm
Unutarnji promjer 2 [mm]:38 mm
Težina [kg]:0,4 kg
Boja:crna
Duljina crijeva [mm]:419 mm
Unutarnji promjer 3 [mm]:20 mm
prikladno za vrstu vozila:Osobno vozilo

Hiter pogled

Podrobnosti ...

Cevi hlajenja motorja in prirobnice

VAICO Gibka cev hladilnika

Blagovna znamka:VAICO
Vrsta mjenjača:Ručni mjenjač
Polazni/povratni vod:za polazni vod
za OE broj:17 12 7 521 777
Vod za hlađenje:od termostata prema hladnjaku motora

Podrobnosti ...

-33%

Trenutna akcija traje do: 21.05.2024 00:00.

Cijena:

75,10 €

Sniženo:

50,32 €

Šifra: VAI-V20-1289

Najniža cijena u zadnjih 30 dana: 50,32 €

Blagovna znamka:VAICO
Vrsta mjenjača:Ručni mjenjač
Polazni/povratni vod:za polazni vod
za OE broj:17 12 7 521 777
Vod za hlađenje:od termostata prema hladnjaku motora
Težina [kg]:0,383 kg
Opće informacije:Products supplied by us are without exception intended for
the designated use.
Please note that our products are usually delivered without
installation instructions.
Installation may only be carried out by trained specialist
personnel.
There is no guarantee for inappropriate, improper or
unintended use.
, In the warranty, we always make a distinction between wear
parts and vehicle parts. All wear parts are subject to a
reduced warranty period and a maximum mileage.

Brake components such as brake disks, brake pads, etc.
maximum of 1000 km (break-in period). Therefore, warranty
claims for brake parts are only reviewed with an
installation invoice and a record of the wheel hub run-out
measurement, including photos.

For brake disks and brake pads, the break-in requirements
specified by the vehicle manufacturer must be observed.

When replacing brakes, the chassis components must always be
checked with regard to clearance and the wheel hub with
regard to wobble, and the appropriate documentation must be
produced.

If the vehicle is no longer in its original condition due to
tuning work such as wheel accessories and tracking plates,
the entitlement to make warranty claims is lost due to
third-party work. The same warranty claims are lost if the
vehicle is used for motor sports or similar events.